Dry Pipe Sprinkler Systems
Dry Pipe Sprinkler Systems hold compressed air rather than water in the main pipes, so they do not freeze in cold sites. When any sprinkler head opens, air is lost and the dry pipe valve opens to allow water flow. They differ from wet systems by delayed response and are one of the suitable solutions for areas exposed to freezing, such as cold warehouses and parking garages.
(0 products)
About this category
Dry pipe systems extend automatic sprinkler protection to cold environments. The design: steel pipes run across the ceiling filled with compressed air or nitrogen (typically 2-4 bar), a dry pipe valve that separates pressurized water from the air-filled piping, an air compressor to make up leaks and maintain pressure, and upright heads or listed dry-pendent sprinklers. Activation: when a head opens from heat, compressed air escapes through it, air pressure in the pipes drops, the dry pipe valve opens, and water flows from the source to the open head. Total response time: 15-60 s depending on network size (versus 1-5 s for wet systems). Applications: refrigerated warehouses, unheated parking garages, industrial areas in cold climates, unheated plants, freezer stores, and exposed balconies and entrances. A substantive difference from wet systems: dry requires an air compressor, a more complex valve, higher maintenance, but does not freeze; wet is simpler and faster but susceptible to frost. A critical technical note: the time delay in dry systems limits effectiveness against fast-spreading fires; single-network size is therefore capped per NFPA 13 (the maximum system capacity depends on water-delivery time and the adopted NFPA 13 edition, and must be verified in design). Sloped drainage is required to remove water after activation. Maintenance: annual trip test of the dry valve, weekly air-pressure check, and internal rust cleaning. Specifications follow NFPA 13, NFPA 25, and EN 12845.
Read moreHide details
Dry pipe systems extend automatic sprinkler protection to cold environments. The design: steel pipes run across the ceiling filled with compressed air or nitrogen (typically 2-4 bar), a dry pipe valve that separates pressurized water from the air-filled piping, an air compressor to make up leaks and maintain pressure, and upright heads or listed dry-pendent sprinklers. Activation: when a head opens from heat, compressed air escapes through it, air pressure in the pipes drops, the dry pipe valve opens, and water flows from the source to the open head. Total response time: 15-60 s depending on network size (versus 1-5 s for wet systems). Applications: refrigerated warehouses, unheated parking garages, industrial areas in cold climates, unheated plants, freezer stores, and exposed balconies and entrances. A substantive difference from wet systems: dry requires an air compressor, a more complex valve, higher maintenance, but does not freeze; wet is simpler and faster but susceptible to frost. A critical technical note: the time delay in dry systems limits effectiveness against fast-spreading fires; single-network size is therefore capped per NFPA 13 (the maximum system capacity depends on water-delivery time and the adopted NFPA 13 edition, and must be verified in design). Sloped drainage is required to remove water after activation. Maintenance: annual trip test of the dry valve, weekly air-pressure check, and internal rust cleaning. Specifications follow NFPA 13, NFPA 25, and EN 12845.
No products in this category yet
No products in this category yet
Browse the similar categories, or request a quote for what you need and we will source it.