Bump Test Equipment
Bump Test Equipment is simple portable gear used to confirm a detector's response to gas before every use at an industrial work site. It differs from full calibration by being a quick check that confirms the sensor works and the alarms fire properly, without adjusting numerical reading accuracy. Essential before every new work shift.
(0 products)
About this category
A bump test is the fundamental daily check for every in-service gas detector. The principle: expose the detector to a known gas concentration for a short time and confirm the alarm triggers. It does not adjust reading accuracy (that's full calibration), but confirms that the sensor responds and the alarms work. The design: a simple kit of a regulator (a flow regulator specific to calibration gas at a steady flow), a hose and adapter (connecting the cylinder to the detector), and sometimes a small bump station (a portable platform to ease testing). Typical cycle: 1) power the detector and attach the adapter, 2) open the valve to expose the detector to gas for a defined short period, 3) confirm audible and visual alarms trigger, 4) close the valve and verify the sensors return to their expected fresh-air baseline per the instrument manual (about 20.9% on the oxygen channel and near zero for other gases), 5) log the result. Typical frequency: before every shift for most applications, after every use in harsh environments — the actual frequency is set per facility policy and site requirements. Applications: oil and gas, chemical plants, response teams, large construction sites, technical-service companies, and confined-space pre-entry checks. A substantive difference from calibration: a bump test is a brief response check; a full calibration is a longer procedure that sets reading accuracy. A technical note: a failed bump requires immediate inspection — it may indicate a damaged sensor, a blocked inlet or a circuit fault, and the unit is removed from service until calibrated or repaired. Test settings vary between detector models and manufacturers — review the product documentation.
Read moreHide details
A bump test is the fundamental daily check for every in-service gas detector. The principle: expose the detector to a known gas concentration for a short time and confirm the alarm triggers. It does not adjust reading accuracy (that's full calibration), but confirms that the sensor responds and the alarms work. The design: a simple kit of a regulator (a flow regulator specific to calibration gas at a steady flow), a hose and adapter (connecting the cylinder to the detector), and sometimes a small bump station (a portable platform to ease testing). Typical cycle: 1) power the detector and attach the adapter, 2) open the valve to expose the detector to gas for a defined short period, 3) confirm audible and visual alarms trigger, 4) close the valve and verify the sensors return to their expected fresh-air baseline per the instrument manual (about 20.9% on the oxygen channel and near zero for other gases), 5) log the result. Typical frequency: before every shift for most applications, after every use in harsh environments — the actual frequency is set per facility policy and site requirements. Applications: oil and gas, chemical plants, response teams, large construction sites, technical-service companies, and confined-space pre-entry checks. A substantive difference from calibration: a bump test is a brief response check; a full calibration is a longer procedure that sets reading accuracy. A technical note: a failed bump requires immediate inspection — it may indicate a damaged sensor, a blocked inlet or a circuit fault, and the unit is removed from service until calibrated or repaired. Test settings vary between detector models and manufacturers — review the product documentation.
No products in this category yet
No products in this category yet
Browse the similar categories, or request a quote for what you need and we will source it.